Bluetooth App
Bluetooth LED Chord App
Included in your order is an index card with QR codes that directly link you to the app store.
Download The App
Controller Name: Rhino Music
Rhino Lights LLC as of right now uses an app called LED Chord to control our lights. Use the link below that matches the phone you have to download the app.
The controller should be installed in a location away from any heat sources (engine, exhaust, etc.). The controller is waterproof, but it does contain a microphone (used for music mode) that can be affected by mud/water, mount the controller in a place that will not become overly wet or muddy for best results using Music mode.
How to Use the App
Verify Settings
Warning: You must be CONNECTED to the bluetooth controller for it to read and set the settings on the controller.
Unconnected
Connected
Settings
Once you are connected you can verify to make sure the settings match the settings to your configuration. The # of segments is determined by your product with the most amount of LEDS. Example: You have a pair of 4ft whips and 6 rock lights, the segments would be 10.
- RGB Sequence - GRB
- LED Driver - WS2811
| WHIP SIZE | SEG. | PEXELS / SEG. | TOTAL PIXELS |
|---|---|---|---|
| Rock Lights ONLY | 2 | 16 | 32 |
| 12" Whips | 3 | 16 | 64 |
| 18" Whips | 4 | 16 | 64 |
| 2ft Whips | 5 | 16 | 80 |
| 3ft Whips | 8 | 16 | 128 |
| 4ft Whips | 10 | 16 | 160 |
Advanced Settings
With the LED Chord app you are able to change how the whips look by changing the segments and the pixels / seg. Above are the rough total of LEDs per each whip so as long as your numbers are equal or greater then the below numbers it will fill the whip out.
Step 1 - Prep
Step 2 - App
Step 3 - Install
-- Core Products --
-- Accessory Products --