All systems

Install help · Switched 12V lights

Installing Switched 12V lights

Wired to a switch. No app, no controller. Covers Diamond Duo rock lights, Twin Color pod lights, Step lights, Mini 12V rock lights, Light bars.

Not Switched 12V? RGB RGB+W RhinoLink

01Prep

Read this before you wire.

For Switched 12V lights

  • These lights run on plain 12V through a switch. They do not use the Bluetooth controller or the app.
  • Diamond Duo has two channels, colour and white. Run each to its own switched 12V feed so you can turn them on separately.
  • Diamond Duo cannot share a setup with RGB or RGB+W lights.
6 rules for every install
  • Wire the controller through a switchWired straight to the battery it draws power all the time and drains it.
  • Keep the controller away from heatNot near the engine or exhaust. The housing survives the heat; the electronics inside do not.
  • Never plug or unplug with the power onThe surge can damage the lights. That counts as install damage and is not covered.
  • 12 volts onlyMore than 12V damages the lights and voids the warranty.
  • Test before you secure anythingLay everything out, power it up and check it all works before you run and tie down wire.
  • No bare wires touchingCheck every connection before power goes on, and use waterproof connections.
Next step 02 Install guides

02Install guides

Guides for your Switched 12V lights.

Download the PDF, watch the video, or both. PDFs open in a new tab, so you can keep this page.

Wiring & switches

Next step 03 Add-ons

03Add-ons

Turn signals, switches and more.

Duo wiring harness

Pre-built switched wiring for Diamond Duo.

Coming soon Guide on the way. Need help now? Call 704-270-2695
View product
Next step 04 Help

04Help

Stuck? We built it.

Check troubleshooting first: most problems are a loose connection or a wrong setting.

Still stuck? Call 704-270-2695. If a light has failed, start a repair.

All systems